Raspuns VP 2110 blocks when entering in “Sleep Mode” Time for the “Low Power” mode must be set lower than the time for the “Sleep” mode
[ Sus ]
TDS: Why does the toner wipe off the copy /print Check if:
- the equipment is set to print on paper /tracing paper or film;
- the paper/tracing paper type and weight is set correctly; [ Sus ]
All / The equipment does not print Check if:
- the controller is on
– you are physically connected to it
– it replies to pings
– you are using the adequate driver
– you are using the adequate port
– you are trying to print a “test print” from the driver. If the equipment does not print the test page, reinstall the driver. [ Sus ]
All / The equipment does not respond Restart the entire system, controller included. [ Sus ]
Suport tehnic
